Can't send mail using WLM

[Char Jackson]

Yes, and I will now delete the old account and continue using the newly
created one.

You've verified that the newly created account can both send and
receive, so at this point I would simply clear out the settings for
the old account and re-enter them, especially the sending part.

This doesn't answer the question as to why it happens, but I'm satisfied
that I can now correct it easily if it occurs again.

I'm not sure why, either.

This only leaves me one problem...
How to re-address all 65 outgoing messages in my old account in bulk!
I've done it singly and it works, but I don't want to have to call in each
message individually to re-address them.

I'm not sure what that means or why it's necessary, so I'll leave that
part to someone else. Like I said above, though, if it were me I'd
repair the existing account instead of creating and using a new one.

 

[FiOS-Dave]

You've verified that the newly created account can both send and
receive, so at this point I would simply clear out the settings for
the old account and re-enter them, especially the sending part.


I'm not sure why, either.


I'm not sure what that means or why it's necessary, so I'll leave that
part to someone else. Like I said above, though, if it were me I'd
repair the existing account instead of creating and using a new one.

I tried repairing the old account and it still didn't work!
It's simple and quick enough to create a new one, so that's what I
finally did. I think I will start a new thread with my last question so
I can stop watching this thread...it's getting too long!!!

Thanks again,
Dave